Design and simulate analog and digital circuits using PSpice. Because the analog and digital simulation algorithms are built into the same program, PSpice A/D simulates mixed-signal circuits with no performance degradation because of tightly coupled feedback loops between the analog and digital sections.
Limited versions of the following products are included in the Student Version of PSpice:
PSpice A/D 9.1, Web Update 1, including PSpice Schematics 9.1
Your choice of schematic editors (specify during installation)
PSpice Schematics 9.1
Capture 9.1, Web Update 2
(Visit Electronics-lab for PSpice tutorials)
DOWNLOAD
Showing posts with label circuit. Show all posts
Showing posts with label circuit. Show all posts
Saturday, November 20, 2010
Friday, September 10, 2010
Superposition
Superposition is a good method to apply in analyzing circuits with multiple sources. The basic concept of this method is to analyze a circuit one source at a time. Using the Superposition Theorem, we remove all the independent sources, except one, and analyze that circuit for that one. Then we repeat the procedure for another source, and so on. Finally, the net result is found by summing all the single -source results.
'Removing' Power Sources
If we have two voltage sources and we were to remove one source, and still have a complete circuit, we must replace the voltage source with a short circuit.
Tuesday, September 7, 2010
Source Transformation
In order to solve difficult and complicated circuits, it is important to simplify the given circuit for easier analysis. One way to simplify circuits is by Source Transformation. It is the process of using Ohm's Law to take an existing voltage source in series with a resistance, and replace it with a current source in parallel with the same resistance or vice-versa. This method can be applied to Thevenin's theorem and Norton's theorem.
![]() |
| Source Transformation for Independent Sources |
Friday, July 30, 2010
Wye-Delta Conversion
In many circuits, resistors are neither in series nor in parallel, so the rules for series or parallel circuits described in previous chapters cannot be applied. For these circuits, it may be necessary to convert from one circuit form to another to simplify the solution. Two typical circuit configurations that often have these difficulties are the wye (Y) and delta (D) circuits.
Wye to Delta
Wye to Delta
Subscribe to:
Posts (Atom)




